Filter
Top Products
FOX 2G Tx/Rx AV • Installation and Setup
2-11
Video Connections
The FOX 2G Tx/Rx AV accepts a single low resolution video
signal (composite, S-video and low resolution component video)
and outputs a single low resolution video signal (composite,
S-video and low resolution component video). It is not
compatible with RGB or HDTV 480p, 720p, or 1080i component
video signals.
The transmitter converts incoming signals to a proprietary
format and passes them along the ber optic cable to the FOX
2G Rx AV. The receiver converts the signal to a format that
matches the display requirements. SIS
™
commands are used to
congure the receiver to convert between signal formats (see
page 3-10).
To input a low resolution component signal,
or output a component output signal, connect
three BNC male connectors to the Y/VID,
B-Y/C, and R-Y receptacles on the back panel of
the unit.
There are two alternative methods to input or
output an S-video signal:
Connect BNC male connectors to the •
Y/VID and B-Y/C receptacles on the back
panel of the unit.
Connect a 4-pin mini DIN to the S-VID •
receptacle on the back panel of the unit.
N
In addition to the selected output type,
using BNC connectors, a transcoded
S-video signal is always output from
the receiver's S-VID socket.
To input or output a composite signal, use
a single BNC male connector to the Y/VID
receptacle on the back panel of the unit.
When both the BNC connectors and the 4-pin
mini DIN provide simultaneous video input,
the signal with the highest priority for video
output is highlighted in the table below:
BNC Input Mini DIN Input
Component S-Video
S-Video S-Video
Composite S-Video
Y/VID
R-Y S-VID
B-Y/C
S
-VI
D
Component
Y/VID
R-Y S-VID
B-Y/C
S
-VID
S-video
R
-
Y
Y/VID
R-Y S-VID
B-Y/C
Y/
VI
D
S-video
R-
Y
B-Y
/C
Y/VID
R-Y S-VID
B-Y/C
S
-VID
Composite
R-
Y
B-Y
/C