Filter
Top Products
DVC 501 SD • Reference Information 30
Rack mounting procedure
To rack mount the converter, you can use one of the Extron 19 inch rack shelf mounting
options (see “Optional Accessories,” earlier in this section, for part numbers).
DVC 501 SD
DIGITAL VIDEO CONVERTER
(2) 4-40 x 3/16" screws
Use 2 mounting holes on
opposite corners.
Half-rack
false front panel
uses 2 front holes.
Figure 27. Rack Mounting the DVC 501 SD
1. If rubber feet have been installed on the bottom of the unit, remove them.
2. Mount the DVC on the rack shelf using two 4-40 x 3/16 inch screws in opposite
(diagonal) corners to secure the unit to the shelf.
3. (Optional) Attach a blank panel or other unit to the rack shelf.
4. Insert the shelf into the rack, aligning the holes in the shelf with those in the rack.
5. Secure the shelf to the rack using the supplied machine screws. This shelf can be
mounted in the front or in the rear of the rack.
Under-desk Mounting
The DVC 501 SD can also be mounted under furniture, such as a table or podium surface,
using the optional MBU 125 under-desk mounting kit (see “Optional Accessories” for the
part number).
1. If rubber feet were previously installed on the bottom of the unit, remove them.
2. Attach the mounting brackets to the unit with
the included machine screws.
3. Insert #8 wood screws into the four pilot holes.
Tighten each screw into the mounting surface
until slightly less than 1/4 inch of the screw
protrudes.
4. Align the mounting screws with the slots in the
brackets, and place the converter against the
surface with the screws through the bracket
slots.
5. Slide the unit slightly forward or back, then tighten all four screws to secure it in place.