Filter
Top Products
DVC 501 SD • Operation 11
• Overheating — The Temperature Overload!!! screen is added to the default cycle if
the internal temperature of the unit exceeds 65 °C (149 °F).
TEMPERATURE
OVERLOAD!!!
INPUT
HDSDI 1.485G
INPUT
720p @59.94Hz
5 sec.
5 sec.
5 sec.
Figure 12. Example of the Default Cycle When the Unit Is Overheating
• Video muted — The input resolution and rate screen (second screen of the default
cycle) displays a blinking asterisk (*) on both sides of the word INPUT. The asterisks
disappear when the video is unmuted (the asterisks also appear on the INPUT NO
SIGNAL! screen during video muting.)
INPUT
HDSDI 1.485G
* INPUT *
720p @59.94Hz
5 sec.
5 sec.
Figure 13. Example of the Default Cycle When the Video Is Muted
To mute and unmute the video, see the Video Mute SIS commands in the “Remote
Configuration and Control” section.
Menus on the LCD Screen
The DVC 501 SD menus that are displayed on the LCD screen enable you to configure
and operate the converter. The menu navigation buttons (Menu and Next) are located to
the right of the LCD screen. Press these buttons to cycle through the available menus and
submenus, and use the horizontal and vertical Adjust knobs to select options.
This section provides information on the menus and submenus, including any procedures
that are initiated from them.
Menu System Overview
The menu system consists of three menus, which have submenus that enable you to make
desired adjustments (see the menu flow diagram on the next page).
Using the menus
1. To access the menu system, press the Menu button. The first menu (OUTPUT CONFIG) is
displayed on the LCD screen.
2. Select other menus by repeatedly pressing the Menu button until the desired menu is
displayed.
3. Press the Next button repeatedly to cycle through the submenus for the selected menu.
4. When the desired submenu is displayed, rotate the horizontal ([) or vertical ({) Adjust
knob clockwise or counterclockwise to cycle through the submenu options. If you want
to return to a menu from within one of its submenus, press Menu.
5. When the desired option is displayed, do one of the following to select it:
• Press Next to display another submenu.
• Press Menu repeatedly until the EXIT MENU PRESS NEXT screen appears, then press
the Next button to return to the default cycle.
• Wait until the LCD screen returns to the default cycle (approximately 30 seconds).