Filter
Top Products
DVC 501 SD • Reference Information 27
Video output
Number/signal type ........................ 1 single link DVI-D
1 RGB, YUV / YPbPr
Connectors .................................... 1 female DVI-I
1 female 15-pin HD
Nominal level
TMDS ...................................... 1.0 Vp-p swing
Analog .................................... 1 Vp-p for Y of component video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
Impedance
TMDS ...................................... 100 ohms
RGB ......................................... 75 ohms
Return loss ..................................... <-25 dB @ 100 MHz
DC offset ....................................... ±5 mV with input at 0 offset
Sync
Output type ................................... RGBHV, RGBS, RGsB, component video (bi-level or tri-level)
Output level ................................... 5.0 Vp-p for RGB
0.6 Vp-p for component video tri-level sync
0.3 Vp-p for component video bi-level sync
Output impedance ......................... 75 ohms
Output polarity ............................... Positive or negative (selectable)
Audio
Frequency response ........................ 20 Hz to 20 kHz, ±0.2 dB
THD + Noise ................................... 0.05% @ 1 kHz at nominal level, 0 dB gain
S/N ................................................. >100 dB at maximum output (unweighted)
Stereo channel separation .............. >80 dB @ 1 kHz
Audio input
Number/signal type ........................ 1 SDI embedded audio (SMPTE 272M, SMPTE 299M)
Connector ...................................... 1 female BNC
Adjustment range .......................... -18 dB to 0 dB
Audio output
Number/signal type ........................ 1 stereo, balanced/unbalanced
Connectors .................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance ..................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.1 dB channel to channel
Maximum level (Hi-Z) ...................... +21 dBu, balanced, or +15 dBu, unbalanced, at 0.05% THD+N
Control/remote
Serial control port ........................... 1 RS-232, 3.5 mm captive screw connector, 5 pole (uses 3 poles)
Baud rate and protocol ................... 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration ....... 3 = Tx, 4 = Rx, 5 = GND
USB control ports ........................... 1 front panel female mini USB type B
USB standards ................................ USB 2.0, low speed
Program control ............................. Extron Simple Instruction Set (SIS)