Filter
Top Products
37
ENGLISH
Symptom RemedyPossible problem
• Check the IP address, gateway address and
subnet mask settings.
<LAN>
• The network settings have not been made.DN-V1700 not recognized.
• Reset the IP addresses.
• The IP addresses are redundant.
✽ When multiple units of the DN-V1700 are
connected, their IP addresses must not be
redundant. When connected to an existing
LAN, the IP addresses must not be
redundant.
• Contact the administrator of the LAN to which
the DN-V1700 is connected.
• Access is limited by firewall or router.
SNTP time setting cannot be
made.
20
MAIN SPECIFICATIONS
Playable formats:
Playback medium:
Input/output terminals:
Video performance:
Audio performance:
Internal clock error:
External dimensions:
Mass:
Power supply:
Power consumption:
Surrounding conditions:
Period of warranty:
<Video + audio or video only>
ISO/IEC 13818-1 MPEG2 MP@ML PS (Program Stream) files (video + audio)
ES files (video only) Resolution: 720 x 480
<Still images>
ISO/IEC 13818-2 MPEG2 MP@ML ES files
Resolution: 720 x 480 per frame intraframe
<Audio format>
MPEG1 – Audio Layer 2 (ISO/IEC 11172-3)
Sampling frequency: 48 kHz, 44.1 kHz
<Max. baud rate>
Max. 10 Mbps total for video + audio (as per card performance)
DENON recommended flash memory card
Internal hard disk drive
Component video (Y/Cb/Cr) output BNC terminal
Composite output BNC terminal, composite output RCA terminal
Y/C separated signal output S terminal, VITC input BNC terminal, VITC output BNC terminal
Analog output RCA terminal (stereo) x 2
Analog output balanced active, XLR connector x 1
Digital audio output RCA terminal (EIAJ format)
DC input terminal, serial mode (D-sub female 9 pin) terminal (for both RS232C and RS422A)
Parallel remote (D-sub female 15 pin) terminal
Ethernet (LAN) (RJ-45) terminal (10 Base-T/100 Base-TX, automatic selection)
Video outputs Composite: 1.0 Vp-p (negative resistance 75 Ω/ohms)
S-Video: Y (brightness) signal: 1.0 Vp-p (negative resistance 75 Ω/ohms)
C (color) signal: 286 mVp-p (negative resistance 75 Ω/ohms)
Component: Y (brightness) signal: 1.0 Vp-p (negative resistance 75 Ω/ohms)
Cb (color) signal: 0.7 Vp-p (negative resistance 75 Ω/ohms)
Cr (color) signal: 0.7 Vp-p (negative resistance 75 Ω/ohms)
Sampling frequency: 13.5 MHz
S/N ratio: 50 dB or greater
RCA output level: 1.3 Vrms (negative resistance 10kΩ/kohms: 1 kHz, 0 dB playback)
Balance output level: +18 dBm, 600 Ω/ohms: 1kHz, 0 dB playback
Distortion: 0.3% or less (when playing 1 kHz, 0 dB sine wave, using LPF)
S/N ratio: 65 dB or greater (when playing 1 kHz, 0 dB sine wave, using LPF and A-Filter)
Channel separation: 65 dB or greater (stereo, when playing 1 kHz, 0 dB sine wave, using LPF A-Filter)
Frequency response (1 kHz base): Within 0 ±3 dB at 20 to 20 kHz: fs = 44.1 kHz
Within 60 seconds per month
484 (W) x 44 (H) x 375 (D) mm
4.6 kg (not including IC memory card)
AC adaptor (EPA-301DAN-06) Input: AC 120V, 60 Hz
DC 6 V 1.8 A
Operating temperature range: 5 to 35°C
Operating humidity range: 40 to 80%
Storage temperature range: -20 to 60°C (not including playback media)
Storage humidity range: 42 to 90% (not including playback media)
1 year from date of purchase (not including playback media)
✽ For improvement purposes, specifications and design are subject to change without notice.