Filter
Top Products
35
ENGLISH
• OSD error display
If an error occurs in the DN-V1700, a description of the error is displayed on the OSD.
The error message displayed with this function is the same as that returned with the “?E” serial command.
• Display of error messages
If an error occurs, the PLAY/PAUSE and STOP buttons on the main unit flash at 1-second intervals, indicating that an error has
occurred.
At this time the OSD/TIME SET button on the main unit can be used to turn the OSD on and off. When switched from off to
on, the error message appears at the bottom of the screen.
If an error occurs when the system OSD display is turned off, the error message is displayed when the system OSD is turned
on. If the error occurs when the system OSD display is turned on, the error message can be displayed by turning the system
OSD off then back on.
When the error message is displayed, the keys on the front panel stop flashing and the display returns to normal.
If another error occurs while an error message is displayed, the new error is immediately displayed.
If an error message is displayed while the user OSD is displayed, the user OSD cannot be displayed again until the error
message is cleared.
• Storing error messages
If a second error occurs after a first error has occurred but has not yet been displayed, the old message is cleared and the new
message is stored.
In addition, if after an error occurs and before the error message is displayed on the OSD the error is confirmed with the “?E”
serial command, the keys on the front panel stop flashing and the error message is cleared.
• User OSD display
Any character string can be displayed on the user OSD using the “AT”, “PR” and “CS” serial commands. The user OSD cannot
be displayed at the same time as the status display. If both are turned on, the status display has priority.
Letters (capital or small), numbers and symbols can be used on the user OSD, which can contain a maximum of 14 rows each
with a maximum of 44 characters (upper left coordinate: 0,0). For some monitors, however, some parts at the edges of the
screen may not be displayed.
✽ The user OSD is controlled by serial command.
For details, consult your store of purchase.