Filter
Top Products
ENGLISH
15
o
COMPOSITE VIDEO OUTPUT terminal (RCA)
This is a composite video output. Connect it to a monitor
display equipped with a composite video input using a 75
Ω/ohms RCA cable. The connected device must be
terminated at 75 Ω/ohms.
!0
S-VIDEO OUTPUT terminal
This is an S-Video output terminal. Connect it to a monitor
display equipped with an S-Video terminal using an S-Video
cable.
!1
COMPONENT VIDEO OUTPUT terminal
This is a component video output. Connect it to a monitor
display equipped with a component video input.
!2
MASTER/SLAVE selector switch
Use this to select the set’s operating mode, master or slave.
The setting is detected when the power is turned on, so if it
this switch is operated, turn the power off then back on.
7
SYNCHRONIZATION CONNECTIONS
The DN-V1700 allows synchronized playback in units of frames using external VITC time code signals. Synchronized playback is also
possible using a slave generator function that generates time codes synchronized to video signals (vertical/horizontal synchronizing
signals) not including VITC time code signals.
When and only when using the DN-V1700 as a slave device of another device equipped with the VITC signal generating function, set the
MASTER/SLAVE selector switch on the rear panel to the SLAVE side. In all other cases (when not synchronizing the DN-V1700 with
another device or when synchronizing another device using the DN-V1700’s VITC signals), set the MASTER/SLAVE selector switch to the
MASTER side.
[Example of connections - 1] Synchronization connection of three DN-V1700s
SYNC.
(
VITC
)
MASTER
SLAVE
IN
OUT
DN-V1700 MASTER
SYNC.
(
VITC
)
MASTER
SLAVE
IN
OUT
DN-V1700 SLAVE
SYNC.
(
VITC
)
MASTER
SLAVE
IN
OUT
DN-V1700 SLAVE
SYNC.
(
VITC
)
MASTER
SLAVE
IN
OUT
SYNC.
(
VITC
)
MASTER
SLAVE
IN
OUT
In this example, the time code generated by the master unit synchronizes the two slave units. Set the master unit’s selector switch to
MASTER, the slave units’ selector switches to SLAVE.
✽ When the flash ROM has been set to the slave generator mode by serial or LAN external control command, the slave generator mode
must be cancelled.
!3
VITC IN terminal
This is the VITC input terminal for operating the set in the
slave mode. It is terminated at 75 Ω/ohms. The input signal
level is 1Vp-p.
!4
VITC OUT terminal
This is the VITC output terminal. The output is for
synchronization with another device.
!5
POWER switch
Set this to the ON side to turn the set’s power on.
!6
DC IN terminal
This is the power input terminal. Connect the included AC
adaptor here.