Filter
Top Products
25
ENGLISH
Send one command at a time.
[Example] To search for the 10th clip and play it
10SE<CR><LF> / Send
R<CR><LF> , Task completed message
PL<CR><LF> / Send
R<CR><LF> , Task completed message
2 Task completed message
This is the message returned to the controller when the task for the operation command (play, etc.) or setting command received
from the controller has been completed normally.
R<CR><LF>
2 Status message
A status message including information on the DN-V1700’s status, etc., can be received by sending a status request command
asking to know the status, etc., of the DN-V1700 from the controller. “R” returns as the terminator at the end of the message.
The format is specific to each command.
2 Message upon startup
If the system is rebooted or the power is turned on from the off status with serial connections made, the message
“OK<CR><LF>” is sent from the DN-V1700.
2 Error messages
If for any reason the task was not completed normally after a command was received from the controller, the DN-V1700 sends the
controller an error message, and the LEDs of the PLAY/PAUSE and STOP buttons on the front of the DN-V1700 flash. The message
consists of an “E” followed by a 2-digit error number.
If you want detailed information on the error after an error command is sent, error confirmation using the “?E” serial command is
possible. Detailed information on the latest error can be acquired. Performing this confirmation stops the keys on the DN-V1700
from flashing, setting the display back to normal. The keys on the DN-V1700 also stop flashing if error message confirmation is
performed with the on-screen display (OSD) first.
The default values in the flash ROM were loaded because the battery backup
memory settings were lost upon startup.
Error code
E00
An attempt has been made to execute a function that is not available.
The command’s instruction section is not correct.
Cannot be used in the current mode.
Argument setting is not within prescribed range.
E04
DescriptionName
Back up memory error
Feature not available
Necessary argument has not been specified.
Argument value is not appropriate.
E06 Missing argument
Irrecoverable error has occurred.
Drive cannot be accessed.
Playback could not be continued and has stopped.
E99 Panic