Filter
Top Products
28
ENGLISH
[2]Setting the speaker distance
• Input the distances from the listening position to the speakers and
set the surround delay time.
• The default settings below are set upon shipment from the factory.
Preparations:
Measure the distances from the listening position to the speakers (L1
to L3 on the diagram at the right).
1
To perform these operations from places other than the
system setting change menu, see page 26.
2
At the SYSTEM SETUP MENU select “DELAY TIME”.
• Switch to the DELAY TIME screen.
3
When “YES” is selected for “DEFAULT”, the delay times for
the various speakers are set to the default values.
4
Select the speaker to be set using the and cursor
buttons, then setting the distance between the speakers and
the listening position using the and cursor buttons.
• Set the distance between the center speaker and listening position.
The distance changes in units of 1 foot (0.1 meters) each time the
button is pressed. Select the value closest to the measured
distance.
5
Enter the setting.
• The SYSTEM SETUP MENU reappears.
FRFL
SRSL
Center
B
9 f t 9 f t
8 f t 8 f t
7 f t 7 f t
FINISH: ENTER BUTTON
DELAY TIME
SELECT :
METERSMETERS FEETFEET
SET THE DISTANCE TO EACH SPEAKERSSET THE DISTANCE TO EACH SPEAKERS
DEFAULTDEFAULT
FRONT&SWFRONT&SW
CENTERCENTER
SURROUNDSURROUND
UNITUNIT
B
8 f t8 f t
7 f t7 f t
FINISH: ENTER BUTTON
DELAY TIME
SELECT :
METERSMETERS FEETFEET
SET THE DISTANCE TO EACH SPEAKERSSET THE DISTANCE TO EACH SPEAKERS
DEFAULTDEFAULT
FRONT&SWFRONT&SW
CENTERCENTER
SURROUNDSURROUND
UNITUNIT
9 f t9 f t
ENTER
L1: Distance from center speaker to
listening position
L2: Distance from front speakers to
listening position
L3
: Distance from surround speaker to
listening position
ENTER
• Use the and cursor buttons to select the distance unit,
“METERS” or “FEET”.
Press the cursor button to proceed to the next step if you do
not wish to change this.
B YES: FRONT & SW / 9ft
CENTER / 8ft
SURROUND / 7ft
B NO: The current settings are used.
The difference of the distances set for the different speakers must
be no greater than 10 ft (3.0 m).
If an inapplicable distance is set, “CAUTION: INVALID DISTANCE”
is displayed. Change the speaker position and reset.
Listening
position
Remote control unit Remote control unit
Remote control unit