Filter
Top Products
14
ENGLISH
(7) Speaker system connections
• Use speaker cords with twisted wire cores and a diameter of 0.6 to 1.5 mm.
Never use cords thicker than 1.5 mm or single-wire cords, as they may
damage the speaker terminals.
• Be sure to interconnect the polarities of the terminals on the speakers and
main unit (≈ to ≈, √ to √).
• When making connections, be careful that none of the core wires of the
speaker cords stick out and touch neighboring terminals, other speaker cords
or the rear panel.
• Speakers with an impedance of 6 to 16 Ω/ohms can be connected for use as
center and surround speakers.
Connection the speaker terminals
1. Push the lever. 2. Insert the cord. 3. Return the lever.
Connections
• When making connections, also refer to the operating instructions of the other components.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
• The protector circuit may be activated if the set is played for long periods of
time at high volumes when speakers with an impedance lower than the
specified impedance are connected.
• Precautions when
connecting speakers
If a speaker is placed near a
TV or video monitor, the
colors on the screen may
be disturbed by the
speaker’s magnetism. If
this should happen, move
the speaker away to a
position where it does not
have this effect.
VIDEO
MON.OUT
S VIDEO
IN IN ININ OUT
TV/DBS
V.AUX
VCR
R
L
AUDIO
IN OUT IN IN ININ OUT
V.AUXTV/DBS VCR
CDR/
TAPE
PRE OUT
SUB WOOFER
IN IN OUT
V.AUXTV/DBS
(OPTICAL)
DIGITAL
SPEAKER SYSTEMS
6 16
R
L
R
L
IMPEDANCE
CENTER SURROUNDFRONT
MON.OUT
Y CB CR
AM
FM COAX. 75
LOOP
ANT.
COMPONENT VIDEO OUT
(L) (R)
(L) (R)
FRONT SPEAKER
SYSTEMS
CENTER SPEAKER
SYSTEM
SURROUND
SPEAKER SYSTEMS
SUB WOOFER
Connector jack for subwoofer
with bilt-in amplifier (super
woofer), etc.