Filter
Top Products
Audio Distribution System Crestron Adagio™ AADS
3. Continue sliding the screwdriver behind the label strip until the top of the
label strip slides out as shown in the following picture.
4. Continue sliding the screwdriver until the entire top of the label strip is
visible. Remove the label strip by pulling the top of the label strip up from
the Adagio component as shown below.
To install the new label:
• Engraved Label Cover: Place the engraved label cover over the label area of
the Adagio component until the label cover’s integrated magnets snap the
label cover into place.
• Printed Label: Place the bottom of the label strip into the Adagio
component. Bend the label strip and position the top of the label strip into
the Adagio component. Replace the label cover over the new label strip.
NOTE: Observe proper orientation so the letters are right-side up.
22 • Audio Distribution System: Adagio AADS Operations Guide – DOC. 6458