Filter
Top Products
Crestron Adagio™ AADS Audio Distribution System
⇒ AAS-2: Audio output A of the AAS-2 must be connected to source
input port 1 and audio output B must be connected to source input port
2.
⇒ AAS-4: Audio output A of the AAS-4 must be connected to source
input port 1. Audio output B must be connected to source input port 2.
Audio output C must be connected to source input port 3. Audio output
D must be connected to source input port 4.
NOTE: If a CEN-IDOC is part of the system, audio output D cannot
be used since the CEN-IDOC is connected to source input port 4.
• Control Devices (Optional): Any combination of six APADs or
C2N-DBF12 devices can be connected to any of the six NET ports on the
rear of the AADS. If an AAE is connected, six more APADs or
C2N-DBF12 devices can be connected.
• AAE (Optional): One AAE can be connected to the AADS’ loop-through
ports and tuner outputs.
NOTE: When using the out-of-the-box functionality, the Net ID of the
AAE is automatically set to its default value (31) when identifying keypads
(refer to page 28). For information on other methods of setting the AAE’s
Net ID, refer to the latest version of the AAE guide (Doc. 6460) which is
available from the Crestron website (www.crestron.com/manuals).
The connections shown in the following diagram must be made for the AADS to
properly control and switch connected devices when using the out-of-the-box
functionality.
CAUTION: Speakers must be rated to full available output.
CAUTION: Do not bridge speaker outputs.
CAUTION: Devices such as the AAS and the AAE must be fully grounded to the
AADS. Additionally, any other source devices should be grounded to the AADS as
well.
NOTE: The AADS can only be powered by the included power cord. Power cannot
be supplied from network devices that are connected to the mini-terminal block
connectors.
NOTE: The AADSI (International version) requires a power cord that is
harmonized to the country’s national and local electrical code. Each inner wire in the
cord should be at least 16 AWG or (1.5 mm
2
) and rated for at least 500V. The
temperature rating of the cord should be at least 60ºC. The cord length should be 1.5
meters to 2 meters.
Operations Guide – DOC. 6458 Audio Distribution System: Adagio AADS • 17