Filter
Top Products
Issue 1.0.2 28 March 2006 © Calibre UK Ltd Page 11 of 30
FREEING INPUT CHANNELS
4.1. Freeing a Video Channel
Should you wish to disable a video input, you may do so by re-selecting that video channel
from the Input Connections menu, selecting the Disable Channel function and then selecting
Yes from the warning message which appears. Disabling a video input channel not only
removes it from the input selections list, it also erases its name and de-allocates its
associated audio channel.
Note: If all possible input channels are disabled, the OSD will exit at the point at which the
last channel is disabled. This is because there are now no valid inputs so Vantage-HD has
switched to its unconfigured (default) mode of operation. In this default mode the input
channel to be displayed is undefined so may vary randomly. To start re-defining the input
channels, press the Menu button again and use the navi-keys to re-enter the Input
Connections menu.
4.2. Freeing an Audio Channel
Should you need to free up a previously allocated channel, go to that video input channel
and select a different audio channel or no audio channel for association with that video input
channel.
Press OK when you have chosen the correct audio channel.
Note: HDMI inputs by default associate themselves with the HDMI audio on that HDMI video
channel. You can change this to any available digital or analog audio input if you wish, but
cannot cross-select audio from a different HDMI video channel, e.g. HDMI2 can use audio
from HDMI2 or from any analog or digital audio input, but HDMI2 video cannot be
associated with audio from HDMI1 input. Calibre recommends use of Coaxial or Optical
digital audio where the source device allows.