Calibre UK VANTAGE-HD Home Theater System User Manual


 
Issue 1.0.2 28 March 2006 © Calibre UK Ltd Page 4 of 30
1.
Connect to
display device
Connect Vantage-HD SVGA (RGBHV) output or HDMI output to your
display device. If connecting a DVI display device you need to use an
HDMI to DVI converter which we recommend you locate at the display
end of the cable.
2.
Connect audio
output
Connect Vantage-HD audio Coaxial, Optical or Analog output to audio
processor, if HDMI audio output is not being used.
Note: For best audio performance it is recommended that Coaxial or
Optical audio be used, not HDMI audio. Some HDMI sources do not
correctly comply with HDMI specifications which can cause audio
distortion or loss of audio. If this is experienced, please change to using
Coaxial or Optical audio, or consult the supplier of that HDMI source
device.
3. Connect input
Connect input video and audio signals to Vantage-HD.
4.
Connect Power
Connect power supply provided with Vantage-HD to Vantage-HD power
inlet jack.
THIS POWER SUPPLY CARRIES A LABEL SHOWING THAT ITS DC
OUTPUT IS 5V at 7A. DO NOT CONNECT ANY OTHER POWER
SUPPLY TO VANTAGE-HD WHICH WILL NOT BE COVERED UNDER
YOUR PRODUCT WARRANTY
Connect the Vantage-HD PSU to your mains outlet and turn on the mains
outlet if it is switched
5.
Configure the
display device
Turn on your display device and select the input channel to which you
have connected Vantage-HD
6.
Switch on
Vantage-HD
Turn on Vantage-HD by pressing the Power (bottom right) button on the
front panel, or by pressing the On button on the remote control.
7.
Set Vantage- HD
output mode
A new Vantage-HD unit will power up in 640x480 @ 60Hz output mode
since this should be compatible with all common display devices. If your
Vantage-HD has previously been connected it may power up in a
different mode. If this mode is not compatible with your display you can
easily revert to the 640x480 @ 60Hz output mode by simultaneously
pressing the front panel Input key and OK key (OK is the center key of
the 5-button navi-key).
8.
Select display
device type
Press the Menu key to bring up the OSD menu. Scroll to the Output
Settings menu using the top/bottom navi-keys. Go into that menu by
pressing the right navi-key.
First choose your type of display by using the up/down navi-keys to scroll
to the Display menu item (if not already highlighted) and pressing OK (the
center button of the navi-key). The options which appear are:
a) LCD - for direct-view LCD displays
b) Plasma - for plasma displays
c) Projector - for solid-state (digital) projectors such as DLP,
LCD, LCOS, DILA or any other type of digital projector
Choosing the appropriate type of display is important since menu items
such as temporal noise reduction and how the OSD is generated are pre-
set to different default values depending on the display type and different
menu items appear or are hidden such as keystone correction.