Filter
Top Products
9. Service Mode
Proj 1
Proj 2 Proj 3 Proj 4
in
in in
in
out
out
out
RS RS RS
Terminator
Image 9-7
Which information is available
serial number
unique serial number of the lamp
type
lamp type
run time total time the lamp is used in this or other projectors.
remaining run time
time left before the lamp must be replaced Using the lamp longer than the maximum run time may
damage the projector.
number of strikes
Total times the lamp is started up.
Z-AXIS indication to adjust the Z-AXIS of the lamp (see Re-adjustment of the lamp position in chapter
Installation Guidelines).
How to display the lamp menu
1. Push the cursor key ↑ or ↓ to highlight Lamp. (menu 9-26)
2. Press ENTER to select.
The lamp menu will be displayed. (menu 9-27)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-26
LAMP
Constant Light output [OFF]
Mode [NORMAL]
Serial number : R101111
Article number : R9840xxx
Run time : 10 hours
Remaining run time : 490
hours
Number of strikes : 10
Z_AXIS : 100
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 9-27
How to switch the constant light output?
1. Push the cursor key ↑ or ↓ to highlight Con stan t Light Output.menu 9-27
2. Press ENTER to togg
le between [OFF], [SLAVE] and [MASTER].
[OFF] fixed power, no power adaptation.
[SLAVE] follows the master pr
ojector to adjust the CLO. When stand alone and the light output should be adjusted,
put on slave.
[MAS-
TER]
master projector to control the CLO in a chain of projectors.
Mode switching
1. Push the cursor key ↑ or ↓ to highlight Mode.menu 9-27
2. Press ENTER to toggle between [NORMAL] and [ECONOMIC].
normal normal light output
eco-
nomic
reduced light output
R5976654 SLM R12+ 09022004
101