Filter
Top Products
96
7. Click “Yes” when asked, “Your desktop has been
reconfigured. Do you want to keep these settings?”
To set the resolution of the second display attached to the
BarcoMed display controller you are working with, go back to the
“Settings” tab of the “Display Properties Control Panel”. Attach
the display by right clicking on the rectangle that represents it
and selecting “Attached”.
Now repeat steps above for this display.
Figure 36: The Windows Display Properties Control Panel Settings
Tab after the drivers have been installed and the resolution set .
Note: The system shown in figure 36 above is a dual-head, single
BarcoMed 2MP2CP display controller. Your system may look
different.