Filter
Top Products
Windows 2000 BarcoMed 2MP2CP software installation
37
If it determines that the Microsoft Installer is either out of
date or missing, it will display the screen shown in figure 11
below. Click “OK” to continue, the wizard will then install a
newer version of the Microsoft Installer.
Figure 11
The BarcoMed Product Installation Wizard will advise you
when it has successfully installed the new version of the
Microsoft Installer. Click “OK”.
The Wizard may prompt you to restart your system. If it does,
click “Yes” to restart your system now.
When your system restarts log in using an account with
administrator privileges. Windows will again launch the
“Found New Hardware Wizard” for each BarcoMed 2MP2CP it
finds in your system. Click “Cancel”. Continue to click
“Cancel” until Windows stops launching the “Found New
Hardware Wizard - Video Controller”. Again, please be
patient as Windows will again scan its library of Plug-and-
Play device drivers to see if it has a driver for your
BarcoMed 2MP2CP controller.
The BarcoMed Software Install Wizard will automatically
restart and the BarcoMed Product Installation Wizard’s
welcome screen will again be displayed (figure 12 below).
5. By default all the software on the BarcoMed Software CD will
be selected. For the initial installation we recommend that
you install all of the software. If you do not want to install a
particular BarcoMed Software product at this time, deselect it
by clearing the checkbox next to it. Click “Install” to
continue or “Cancel” to exit the wizard.