Filter
Top Products
Introduction
20
Proceed as follows:
1. Connect one video output of the first display controller to the
BNC input of the first projector by means of the DVI-to-5 BNC
cable (15 m / 50 ft) (Video 1 in the illustration above).
2. Connect the other PC video output of the first display
controller to the DVI video input of the first display by means
of the DVI cable (Video 2 in the illustration above).
3. Connect one video output of the second display controller to
the BNC input of the second projector by means of the DVI-
to-5 BNC cable (15 m / 50 ft) (Video 3 in the illustration
above).
4. Connect the other PC video output of the second display
controller to the DVI video input of the second display by
means of the DVI cable (Video 4 in the illustration above).
5. Connect a free PC COM port to the RS-232 connector of the
first projector by means of the D-Sub9-to-D-Sub9 cable (15
m / 50 ft).
6. Connect a free PC COM port to the RS-232 connector of the
second projector by means of the D-Sub9-to-D-Sub9 cable
(15 m / 50 ft).
7. Connect the first I-Guard optical sensor to a free PC USB
downstream connector.
8. Connect the second I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
Installation of the sensor is described more in detail in the
section “MediCal and Dicom Theater software installation
and usage”.
Important:
Do not connect the two display inputs nor the two projector
inputs to the same display controller. In other words, to each