Filter
Top Products
Windows 2000 BarcoMed 2MP2CP software installation
38
Figure 12
Driver installation
6. Click “Next” on the Display Driver Wizard’s Welcome Screen
to continue or “Cancel” to exit the Display Driver Wizard and
return to the Software Install Wizard.
The Device Selection Screen’s dialog box (figure 13 on
page 39) should show only those devices physically installed
and supported by the BarcoMed display controller driver on
your BarcoMed Software CD. Select the device you want to
install and then click “Next”.
Note: If there are no BarcoMed devices installed, or if
Windows does not recognize the installed devices, or if the
driver on your BarcoMed Software CD does not support the
installed devices, the dialog box will be empty
1
, and the
BarcoMed driver wizard will exit when you click “Finish” or
“Cancel”.
1. If Windows does not recognize the installed BarcoMed device, special settings
may need to be made in the BIOS to support non-AGP video controllers or to
support multiple video controllers. Check with your PC manufacturer.