Filter
Top Products
Introduction
17
4. Connect a free PC COM port to the second projector RS-232
connector by means of a D-Sub9-to-D-Sub9 cable (15 m / 50
ft).
5. Connect the first I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
6. Connect the second I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
Installation of the sensor is described more in detail in the
section “MediCal and Dicom Theater software installation
and usage”.
c) Single-head with one projector (picture-in-picture)
Figure 3
Proceed as follows:
1. Connect one video output to the projector BNC input by
means of the DVI-to-5 BNC cable (15 m / 50 ft).
2. Connect the other video output to the projector D-Sub15
(VGA) input by means of the DVI-to-VGA cable (15 m / 50
ft).
VIDEO
RS-232
VIDEO
RS-232
USB
Video
RS-232
USB
Video
VIDEO