Filter
Top Products
TECHNICAL DETAILS CAL SPECIFICATION FILES
A-2 ME 7840A OMM
I GENERAL
1. General Structure of file:
2. General syntax:
a. Comma separates all fields.
b. Spaces before or after a keyword or value in each field is acceptable.
c. Place comma between last value and comment.
d. Place a "//" before any comment.
e. MUST have "END" as last line of specification.
f. Comments are acceptable on any line after "END".
g. Keywords are not case sensitive; upper or lower is acceptable. (Examples use case for structural
clarity).
h. If a keyword requires no values or comments, it does not need a comma. (Adding a comma,
however, will not cause a problem.)
i. Never place anything on the first line, except:
ndut, 1, //comment
j. Unless using autocal, suggest always starting with:
ndut 1, //First line of calibration specification
Table A-1. Technical Details of Calibration Specification Files (1 of 9).
<Keyword>, <value 1>, <value 2>, , <value n>, //comment···
{
field
{
field
Header
END
Calibration Specification Section 1
Calibration Specification Section 2
Calibration Specification Section N
·
·
·