Filter
Top Products
11-APR-06 Rev E OMACS3000
45 of 51
System Screens
"Track mode = cccccccccc"
New track mode selected.
"Satellite table contains nnn visible satellites"
Satellite table contains nnn visible satellites.
"Working Satellite table contains nnn satellites"
Working Satellite table contains nnn satellites.
"Modified satellite ID=nnnnn"
Modified satellite.
"Added satellite ID=nnnnn to working table"
Added satellite to working table.
"Selected satellite ID=nnnnn"
Selected satellite.
"Deleted satellite ID=nnnnn from working table"
Delete satellite from working table.
“Start peaking process”
A new peaking process has started.
“Track move repeat request”
A track move did not complete in time allotted so the move is repeated.
"Track move timeout"
Track move timeout - Did not reach commanded position after three move repeats.
"Scan cycle time=nnn, scan cycle level=x.xx, low signal level=x.xx"
Scan cycle time, scan cycle level, and low signal level set.
"MCU error ON (or OFF) - Az VFD fault"
Az VFD fault.
"MCU error ON (or OFF) - El VFD fault"
El VFD fault.
"MCU error ON (or OFF) - Low temperature detected"
Low temperature - LMKVS-CPU is near 0 degrees Celsius.
"MCU error ON (or OFF) - Low Elevation"
Low elevation. Used to inhibit HPA - Not used by majority of systems
"MCU read timeout error ON (or OFF) – no status data for more then 1 second"
No MCU status data for more then 1 second.
"Hand Held Serial Port Open Error"
Hand Held Port Open error.
"Invalid Beamwidth for tracking"
Invalid Beamwidth. - set track to standby.