Filter
Top Products
After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the
cleaned parts are completely dry before inserting the tapes.
To demagnetize the heads
The heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and
increase noise. After 20 to 30 hours use, demagnetize the heads with any commercially available demagnetizer.
Care of discs
• When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.
• After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.
Care of tapes
• Store tapes in their cases after use.
• Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the
sound quality and cause noise.
• Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.
TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating Instructions, check the following guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there a bad connection? (--> page 3)
• There may be a short circuit in the speaker terminals.
--> Disconnect the AC cord, then correct the speaker connections.
• Was an incorrect function button pressed?