Filter
Top Products
3 Press or to select a source, then press ENTER.
• If TUNER is pressed, the band cannot be selected in this step.
• MULTI JOG is also available instead of and .
After you select a source, the duration for the timer-activated period flashes on the display.
4 Select the duration for the timer-activated period with or , then press ENTER.
The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.
• MULTI JOG is also available instead of and .
5 Prepare the source.
To listen to a CD, load the disc.
To listen to a tape, insert the tape into deck.
To listen to the radio, tune in to a station.
6 Press POWER to turn the unit off after adjusting the volume and tone.
When the timer-on time is reached, the unit turns on and begins play with the selected source.
The volume level is automatically set to 20 when the power is turned off with the volume level set to 21 or more.
To check the specified time and source
Press JOG MODE repeatedly until "
¥
" is displayed. The timer-on time, the selected source name and the duration
for the timer-activated period flash alternately for 6 seconds.
To cancel timer standby mode temporarily
Press JOG MODE repeatedly until "
¥
" is displayed, then turn MULTI JOG within 6 seconds until "
¥
" or "
¥
REC" disappears on the display.
To restore the timer standby mode, press JOG MODE repeatedly until "
¥
" is displayed, then turn MULTI JOG
within 2 seconds to display "
¥
" or "
¥
REC".
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.
• Timer playback and timer recording will not begin unless the power is turned off.
• Connected equipment cannot be turned on and off by the built-in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.
Press JOG MODE repeatedly until "
¥
" is displayed, then turn MULTI JOG within 2 seconds until "
¥
REC"
appears on the display. Then press ENTER within 6 seconds.
Carry out the steps of "SETTING THE TIMER" from step 2 and insert the tape to be recorded into deck after step 5.
OTHER CONNECTIONS pg. 17