Filter
Top Products
RADIO RECEPTION pg. 8
MANUAL TUNING
1 Press TUNER/BAND repeatedly to select the desired band.
When
TUNER/BAND
is pressed while the power is off, the previously tuned station will be played (Direct Play
Function).
To select a band with the remote control
Press
BAND
repeatedly.
2 Press
or
to select a station.
Each time the button is pressed, the frequency changes. When a station is received, "TUNE" is displayed for 2
seconds. During FM stereo reception, " "is displayed.
To search for a station quickly (Auto Search)
Keep or pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press or .
• The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press
MODE
on the remote control so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press
MODE
so that "MONO" disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency
allocation system is 9 kHz/step, change the tuning interval.
Press
POWER
while pressing
DIR/ PRESET
during power on.