Filter
Top Products
With power on, press DISPLAY once on the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
When the power is off, press DEMO/ECO repeatedly until the display changes to clock or press once (the time is
displayed for 4 seconds).
To switch to the 24-hour standard
With power on, press DISPLAY then press within 4 seconds. Repeat the same procedure to restore the 12-hour
standard.
If the clock display flashes
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be
reset.
NOTE
After finish setting the clock, the unit will switch to ECO mode.
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
1 Press SLEEP.
2 Within 3 seconds, press or to specify the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute steps.
• MULTI JOG is also available instead of and .