Filter
Top Products
7
En
FM antenna
1
Connect the bare ends of each speaker cord to
the corresponding speaker.
Be sure to use the correct cord for each speaker.
-
Front speaker cords have bare leads at both ends
(approx. 4 m / 13 ft.).
-
Surround speaker cords are the longer cords with a plug
at one end (approx. 8 m / 26 ft.).
The red plug is for the right channel and the white plug
is for the left channel.
-
Center speaker cord is the short cord with an orange
plug at one end (approx. 3 m / 10 ft.).
The copper-colored cords go to the 0 terminal of each
speaker.
2
Connect the cords from the front speakers to the
appropriate terminals on the subwoofer.
- Right front speaker: FRONT R terminals
- Left front speaker: FRONT L terminals
The copper-colored cords go to the 0 terminals.
3
Connect the cords from the surround speakers
to the appropriate jacks on the subwoofer.
- Right surround speaker: SURROUND R jack (red)
- Left surround speaker: SURROUND L jack (white)
4
Connect the cord from the center speaker to the
CENTER jack (orange) on the subwoofer.
5
Connect the subwoofer to the main unit.
Connect the FROM CX-LDV700U jack of the subwoofer
to the TO TS-LW700U jack with the supplied connecting
cord (DIN 8-pin).
AM antenna
•Do not connect other equipment to the TO TS-LW700U
jack because this is used exclusively for the supplied
subwoofer.
6
Connect the supplied antennas.
Connect the FM antenna to the FM 75 Ω terminals and
the AM antenna to the AM LOOP terminals.
7
Connect the television set.
If your TV set has an S-video input jack:
Connect the S-VIDEO OUT (S1) jack of this unit and the
S-video input jack of your TV with an optional S-video
connecting cord.
If your TV set does not have an S-video input jack:
Connect the VIDEO OUT jack of this unit and the video
input jack of your TV with the supplied video connecting
cord (the one with plugs at both ends).
Refer also to the Operating Instructions of your TV set.
The illustration shows the connection to the VIDEO OUT
jack.
•
If your TV set is a wide-screen set: you need to adjust
the TV aspect setting later (see “TV Aspect”, page 33).
•Do not use more than one connection to connect your
TV.
8
Connect the power supply.
Plug in the AC power cords of the main unit and the
subwoofer to AC outlets.
The automatic demonstration will run on the display while
the power is turned off.
To deactivate the automatic demonstration, press DEMO/
ECO. The clock will flash on the display. For setting the
clock, see page 13.
•Do not short-circuit the 0 and 9 speaker cord leads.
•Do not leave objects generating magnetism or objects
affected by magnetism near the speakers.
Remote control
While sliding the latch, pull out the battery holder from the
bottom of the remote control. Place the supplied battery on
the battery holder with correct polarity. Finally, insert the holder
back into position.
•Replace the battery with a new one when the operational
distance between the remote control and main unit becomes
shorter.
•Remove the battery if the unit is not going to be used for an
extended period of time.
•The remote control may not operate if it is used under intense
sunlight or if its line of sight is obstructed.
Caution!
•Do not keep the battery near metallic objects such as rings,
bracelets, and keys. It may cause the battery to short circuit.
•After removing the battery, be sure to keep it out of reach of
children. In case it is swallowed, consult a doctor
immediately.