Filter
Top Products
87 En
CUSTOMIZING THIS UNIT (MANUAL SETUP)
ADVANCED
OPERATION
5 Press k / n repeatedly and then press ENTER
to select and enter the desired submenu.
The following display is an example where “LFE
LEVEL” is selected.
6 Press k / n to select the desired parameter
and then l / h to change the parameter
settings.
• Press h to increase the value.
• Press l to decrease the value.
7 Press SET MENU to exit from “SET MENU”.
Use this menu to manually adjust any speaker settings.
■ Speaker settings A)SPEAKER SET
Use this feature to manually adjust any speaker settings.
y
• If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
• When the diameter of the woofer section of the speaker unit is
larger than 16 cm (6.5 in), set the correspondent speaker setting
parameter to “LARGE” (or “LRG”).
LFE/Bass out LFE/BASS OUT
Use this feature to select the speakers that output the LFE
(low-frequency effect) and the low-frequency signals.
Choices: SWFR, FRONT, BOTH
• Select “SWFR” (subwoofer) if you connected a
subwoofer. The LFE signals as well as the low-
frequency signals of other speakers set to “SML” (or
“SMALL”) are directed to the subwoofer.
• Select “FRONT” (front) if you did not connect a
subwoofer. The LFE signals, the low-frequency signals
of the front left and right channels, and the low-
frequency signals of other speakers set to “SML” (or
“SMALL”) are all directed to the front left and right
speakers regardless of the “FRONT SP” setting (see
page 87).
• Select “BOTH” (both) if you connected a subwoofer.
The low-frequency signals of any source are output
from the subwoofer. The LFE signals as well as the
low-frequency signals of other speakers set to “SML”
(or “SMALL”) are directed to the subwoofer. The low-
frequency signals of the front left and right channels
are directed to the front left and right speakers and the
subwoofer regardless of the “FRONT SP” setting (see
page 87).
.SPEAKER;;;;;;0dB
HEADPHONE;;;;0dB
[]/[]:Up/Down
[]/[]:Adjust
B)LFE
LEVEL
p
p
p
[
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
MENU
SRCH MODE
SET MENU
1 BASIC MENU
. A)SPEAKERSET
B)SPLEVEL
C)SPDISTANCE
D)TESTTONE
2 BASIC
MENU
[]/[]:Up/Down
[ENTER]:Enter
p
p
SWFRFRONTBOTH
LFE/BASS OUT
[
01EN_00_RX-V1700_U.book Page 87 Tuesday, June 27, 2006 9:37 AM