Filter
Top Products
107 En
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
3 Press k / n to select and enter a character.
Pressing n changes the character as follows:
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),
/ (slash), and space.
Pressing k changes the characters in reverse order.
4 Press h to move the cursor to the next
position.
y
Press l to move the cursor to the previous position.
5 Press ENTER to set the new name.
“OK” appears in the display window on the remote
control if renaming was successful.
“NG” appears in the display window on the remote
control if renaming was unsuccessful. In this case,
start over from step 3.
y
If you continuously want to rename another input area, press
the input selector button or , or press SELECT k / n
repeatedly to select the component, then repeat steps 3
through 5.
6 Press RENAME again to exit the renaming
mode.
“ERROR” appears in the display window on the remote control if
you press a button not indicated in the respective step, or when
you press more than one button simultaneously.
y
This feature is useful when you change the input or output
assignment for digital jacks and component video input jacks.
Refer to “INPUT RENAME” on page 95.
The macro programming feature makes it possible to
perform a series of operations with the press of a single
button. For example, when you want to play a CD,
normally you would turn on the components, select the
CD input, and press the play button to start playback. The
macro programming feature lets you perform all of these
operations simply by pressing the CD macro button. The
buttons listed as macro buttons below are factory set with
macro programs. You can also program your own macros
(see page 109).
■ MACRO operations
1 Set the MACRO ON/OFF selector to ON.
2 Press the desired macro button.
3 Set the MACRO ON/OFF selector to OFF
when you finish to using the macro
programming operation.
• While the remote control is running a macro program, it does
not accept any other operation until it has completed running
the program (the transmission indicator stops flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation is complete.
Note
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
RENAME
Macro programming features
Notes
V
-
AUX/DOCK
AV
TV
DTV
DVR/VCR 2
VCR 1
DVD
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER CD
MULTI CH IN
SLEEP
AUDIO SEL
POWER
POWER
POWER
STANDBY
XM
ON
OFF
CLEAR
LEARN
RENAME
MACRO
REC
DISC SKIP
MACRO
MACRO ON/OFF
Macro buttons
(U.S.A. model)
ON
OFF
CLEAR
LEARN
MACRO
ON
OFF
CLEAR
LEARN
MACRO
01EN_00_RX-V1700_U.book Page 107 Tuesday, June 27, 2006 9:37 AM