Filter
Top Products
30 En
CONNECTIONS
If you are to use 6 ohm speakers, set “SPEAKER
IMP.” to “6ΩMIN” as follows BEFORE using this
unit. 4 ohm speakers can be also used as the
front speakers.
1 Make sure this unit is turned off.
See page 31 for details about turning on or off this
unit.
2 Press and hold STRAIGHT on the front panel
and then press MASTER ON/OFF inward to
the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Rotate the PROGRAM selector on the front
panel to select “SPEAKER IMP.”.
The following display appears in the front panel
display.
4 Press STRAIGHT on the front panel
repeatedly to select “6ΩMIN”.
The following display appears in the front panel
display.
5 Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
Setting the speaker impedance
CAUTION
MASTER
PURE DIRECT
VOLUME
MAIN ZONE
INPUT
ON
OFF
ENHANCER
NIGHT
ZONE ON/OFF
ZONE CONTROLS
DISPLAY
MODE
TUNING
PRESET/TUNING/CH
SEARCH MODE
EDIT
MULTI ZONE
FM/AM
TUNING
PRESET/
MAN'L/AUTO FM
MEMORY
MIC
OPTIMIZER
EFFECT
STRAIGHT
CATEGORY
CONTROL
SELECT
AUDIO
TONE
A/B/C/D/E
PROGRAM
YPAO
ZONE 3
R
L
OPTICAL
ZONE 2
AUDIO
VIDEO AUX
SILENT CINEMA
S VIDEO
VIDEO
PHONES
ON/OFF
2,432,5
(U.S.A. model)
EFFECT
STRAIGHT
MASTER
While holding
down
PROGRAM
8
MIN
IMP.SPEAKER
Note
EFFECT
STRAIGHT
6
MIN
IMP.SPEAKER
MASTER
01EN_00_RX-V1700_U.book Page 30 Tuesday, June 27, 2006 9:37 AM