Filter
Top Products
119 En
ADVANCED SETUP
ADVANCED
OPERATION
■ Tuner frequency step TUNER FRQ STEP
(Asia and General models only)
Use this feature to set the tuner frequency step according
to the frequency spacing in your area.
Choices: AM10/FM100, AM9/FM50
• Select “AM10/FM100” for North, Central and South
America.
• Select “AM9/FM50” for all other areas.
■ Bi-AMP BI-AMP
Use to activate or deactivate the bi-AMP function.
Choices: ON, OFF
• Select “ON” if you want to activate the bi-AMP
function.
• Select “OFF” if you want to deactivate the bi-AMP
function.
When BI-AMP is set to ON, the SURROUND BACK terminals
cannot be used to connect surround back speakers in that the
SURROUND BACK terminals are already used for the bi-AMP
connection (see page 17).
■ Video reset VIDEO RESET
Use to initialize the parameter settings for “DISPLAY
SET” in “OPTION MENU” (see page 97).
Choices: YES, CANCEL
The parameter setting for “DIMMER”, “SHORT MESSAGE”,
“ON SCREEN” and “FL SCROLL” is not initialized (see
page 97).
W
hen using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
■ Setting remote control AMP ID
1 Set the operation mode selector to AMP or
SOURCE.
2 Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
then press l / h repeatedly until “L;AMP”
appears in the display window on the remote
control.
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3 Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
Note
Note
Setting remote control ID
Notes
TV
SOURCE
AMP
TV
SOURCE
AMP
or
LEARN
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
01EN_00_RX-V1700_U.book Page 119 Tuesday, June 27, 2006 9:37 AM