Filter
Top Products
E-33
ADDITIONAL INFORMATION
CD-Recorder system
notes and limitations
About track length and number
• The CD specifications state that the minimum length of
a CD track must be 4 seconds. If a recording is stopped
while the track is less than 4 seconds long, the unit will
record silence until the 4 second track length
requirement has been reached, and then stop recording.
• CD discs can be recorded with up to 99 tracks on them.
Recording will be automatically stopped if the 99 track
limit is exceeded. Once 99 tracks have been recorded,
no further recording is possible even if time is
remaining on the disc.
About source sampling rate conversion
When recording an analog source (such as an LP or
cassette), this unit converts the analog signals to a 44.1
kHz digital signal before recording them onto the CD-R
or CD-RW disc.
When recording a digital source, this unit converts the
digital signals to 44.1 kHz for recording onto the CD-R or
CD-RW disc. However, if you are recording a 44.1 kHz
source signal (such as another CD disc) there is no need
for conversion. This unit can record 32, 44.1 and 48 kHz
digital signals.
Recording of non-audio signals
This unit is designed exclusively for recording audio
signals. Non-audio signals from sources such as CD-ROM
cannot be recorded. Recording is possible only when the
input digital signal is an audio signal. Similarly, when a
digital signal contains graphic or character information
such as a CD+graphics or CD TEXT disc, the graphic or
character information is not recorded.
When making digital recordings from DAT
When recording from a DAT source, make sure that the
start IDs on DAT tapes are in positions slightly before the
actual audio begins.
DAT tapes that are originally recorded using the DAT
recorder’s auto ID function record the start ID slightly
after the actual recording begins. Because this recorder
uses the start ID on the DAT to indicate the transition
between tracks, the following problems may occur during
synchronized recording (single track or ALL track).
• The beginning of the audio on a track is not recorded.
• A new track number is created slightly after the
beginning of a new track.
• The beginning of the next track is recorded at the end of
a recording.
To avoid these potential problems, it is recommended to
perform manual recording of DAT sources. For more
information on DAT operations, refer to the operating
instructions provided with the DAT recorder.