Filter
Top Products
E-14
RECORDING FUNCTIONS
English
NATURAL SOUND CD RECORDER CDR-S1000
POWER
FINALIZE ERASE DISPLAY
TRACK NO.
EFFECT
REC MODE
OPEN/CLOSE
CD DIRECT
REC
INPUT
PHONES
REC LEVEL
LEVEL
DIGITAL/ANALOG
MIN MAX
010
OPTICAL
COAXIAL ANALOG
REC
MUTE
/
//
EFFECT
FINALIZE
STOP PAUSE PLAY
SEARCH
SKIP
ERASE REC
REC MUTE
123
456
789
+10
0
INDEX
REPEATRANDOM CLEAR PROG
REC MODE
TRACK NO.
WRITE
DIMMERDISPLAY
OPEN/
CLOSE
Synchronized recording
of ALL tracks
This is a recording mode suitable for recording all of the
material from a single audio source such as a CD, MD,
cassette, or LP. Track markers are automatically placed
between the tracks being recorded.
CD-R
CD TOTAL
REMAIN
PROG
RNDM
REPEAT
SINGLE
EFFECT
REC
ALL
AUTO SYNC
TOC
R
dB
L
SF
3244 48.1
–
60 30 10 6 4 2 1 0 OVER00
–––––––
INPUTREC MODE
REC MODE
CD-R
CD TOTAL
REMAIN
PROG
RNDM
REPEAT
SINGLE
EFFECT
REC
ALL
AUTO SYNC
TOC
X2 X4
R
dB
L
SF
3244 48.1
–
60 30 10 6 4 2 1 0 OVER00
–––––––
REC
REC
4 Adjust the recording level as described on page 17.
• The recording level of digital and analog sources
can be adjusted.
• Start playing the source to set the recording level.
When the recording level is set, stop playback of
the source component.
• The recording level cannot be changed when the
CD DIRECT function is on.
5 Ensure that the source is in pause or stop mode, as
synchronized recording cannot be started if the
source is playing.
6 Press REC MODE twice.
• The ALL and SYNC indicators light in the display.
7 Start playing the source.
• The unit starts recording automatically when it
detects an audio signal.
• When making a digital recording, a new track
marker is placed each time a new track begins on
the source component.
• Depending on the source component, a new track
marker may not always be placed correctly. When
this occurs, use the manual track marking function.
• When making an analog recording, spaces of
silence are interpreted as track separations, and a
new track marker is automatically placed when a
new audio signal is detected. The silence should be
about 4 seconds long. Automatic track marking
may not be performed properly if the recording
source has excessive noise or contains a lot of low
level sounds. In this case, we recommend manual
recording as described on page 16.
• Once the unit has recorded 20 seconds of
continuous silence, recording ends and “Wait”
blinks in the display while information is being
written to the PMA (Program Memory Area). After
this is complete, the unit is put in the stop mode.
• When making a recording using the program
playback function of the source component, make
sure that the space between each track is under 10
seconds.
When you are finished recording, follow the
finalization procedure described on page 20.
1 Load a CD-R or CD-RW disc containing space for
recording.
• To ensure proper recording, make sure that you
have more than enough space on the disc.
2 Press REC.
• This unit enters record pause mode.
3 Set INPUT on the front panel to the appropriate input
to be used for recording.