Filter
Top Products
E-15
RECORDING FUNCTIONS
The Full AUTO synchronized recording mode
automatically performs finalization after ALL track
synchronized recording (described on the previous page).
Finalization is the final process in recording a CD-R disc
that makes it playable on standard CD players. (CD-RW
discs can only be played back on a CD-RW compatible
player, even if finalization is performed.) Refer to page 20
for more information on finalization.
Synchronized recording
with finalization
NATURAL SOUND CD RECORDER CDR-S1000
POWER
FINALIZE ERASE DISPLAY
TRACK NO.
EFFECT
REC MODE
OPEN/CLOSE
CD DIRECT
REC
INPUT
PHONES
REC LEVEL
LEVEL
DIGITAL/ANALOG
MIN MAX
010
OPTICAL
COAXIAL ANALOG
REC
MUTE
/
//
EFFECT
FINALIZE
STOP PAUSE PLAY
SEARCH
SKIP
ERASE REC
REC MUTE
123
456
789
+10
0
INDEX
REPEATRANDOM CLEAR PROG
REC MODE
TRACK NO.
WRITE
DIMMERDISPLAY
OPEN/
CLOSE
&
REC MODE
REC MODE
CD-R
CD TOTAL
REMAIN
PROG
RNDM
REPEAT
SINGLE
EFFECT
REC
ALL
AUTO SYNC
TOC
R
dB
L
SF
3244 48.1
–
60 30 10 6 4 2 1 0 OVER00
–––––––
CD-R
CD TOTAL
REMAIN
PROG
RNDM
REPEAT
SINGLE
EFFECT
REC
ALL
AUTO SYNC
TOC
X2 X4
R
dB
L
SF
3244 48.1
–
60 30 10 6 4 2 1 0 OVER00
–––––––
INPUTREC
REC
STOP &
4 Adjust the recording level as described on page 17.
• The recording level of digital and analog sources
can be adjusted.
• Start playing the source to set the recording level.
When the recording level is set, stop playback of
the source component.
• The recording level cannot be changed when the
CD DIRECT function is on.
5 Ensure that the source is in pause or stop mode, as
synchronized recording cannot be started if the
source is playing.
6 Press REC MODE three times.
• The AUTO and SYNC indicators light in the
display.
7 Start playing the source.
• The unit starts recording automatically when it
detects an audio signal.
8 Once the unit has recorded 20 seconds of continuous
silence, recording ends and “Wait” blinks in the
display while information is being written to the
PMA (Program Memory Area). After this is
complete, finalization begins automatically.
• In the Full AUTO synchronized recording mode,
the finalization process following the end of
recording can be canceled by pressing & (STOP &
on the remote) during the 20 seconds of silence at
the end of the recording. If this is done, however, it
will be necessary to perform finalization as
described on page 20.
• When making a recording using the program
playback function of the source component, make
sure that the space between each track is under 10
seconds.
• Operation buttons do not respond once finalization
has begun.
• Never turn the power off during finalization!
• System operation stops automatically without
performing finalization when there is no more
recording time or when 99 tracks have already been
recorded.
1 Load a CD-R or CD-RW disc containing space for
recording.
• To ensure proper recording, make sure that you
have more than enough space on the disc.
2 Press REC.
• This unit enters record pause mode.
3 Set INPUT on the front panel to the appropriate input
to be used for recording.