Filter
Top Products
E-31
ADDITIONAL INFORMATION
SYMPTOM CAUSE REMEDY
If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the
simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the
power cord and contact your authorized YAMAHA dealer or service center for help. When talking to the service center, the
CDR-S1000 may be needed. For details, contact your authorized YAMAHA dealer or service center.
Troubleshooting
The unit does not switch on when
POWER is pressed.
Play does not begin.
Play is delayed, or begins at the wrong
place.
Recording is not possible.
Cannot play back a recorded CD-R or
CD-RW disc on other CD or DVD
players.
Sound “skips.”
Sound “hums.”
Noise from inside of the unit.
The remote control does not work.
TV functions strangely when the
remote control is being used.
Securely connect the power cord.
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after switching the unit on
before trying to play a disc.
Reload the disc with the label side facing up.
Clean the disc.
Check the disc carefully; replace it if necessary.
Load a recordable CD that has not been finalized yet.
For a CD-RW disc, TOC Erase or Disc Erase may be
needed.
Load a recordable CD disc.
Set INPUT to the position that reflects the source of
the input signal.
Set the output level of the source to MAX.
Load a recordable CD disc.
If the recording of a CD-RW disc is interrupted, try
recording again from the beginning. When the
recording of a CD-R disc is interrupted, start recording
over again with a disc that can be recorded on.
Clean or replace the disc.
Use a CD or DVD player compatible with CD-R or
CD-RW discs.
Finalize the disc.
Relocate the unit(s). This is not possible if the
skipping sound is already on the recording due to
vibrations or impact that occurred during recording.
Clean the disc.
Securely connect the audio cables. If the problem
persists, the cables may be defective.
Replace the disc.
Replace the batteries with new ones.
Use within 6 meters and 60 degree radius.
Change the position of the unit.
Relocate this unit away from the TV or cover the
TV’s remote control sensor.
The AC power cord is not connected or not
completely connected.
The disc is damaged.
There is moisture on the laser pick-up.
The disc has been loaded upside down.
The disc is dirty.
The disc may be scratched or damaged.
The disc is finalized.
A pre-mastered CD disc is loaded.
The input setting is incorrect.
The output level of the source is too low.
There is not enough blank space left or 99
tracks have already been recorded on the disc.
If the power cord was unplugged or there was a
power outage during recording, the recorded
material may be lost.
The disc is dirty or damaged.
The CD or DVD players are not compatible
with CD-R or CD-RW discs.
The disc is not finalized.
The unit and/or the component being recorded
is being subjected to vibration or impact.
The disc is dirty.
Improper cable connections.
The disc may be warped.
The batteries of the remote control are too
weak.
Remote control is too far away or is being used
at an incorrect angle.
Direct sunlight or lighting (of an inverter type of
fluorescent lamp, etc.) is striking the remote
control sensor of the unit.
Remote control is being used near TV set with a
remote control sensor.