Filter
Top Products
En 142
FM/AM radio
USB and network
Problem Cause Remedy
FM radio reception is weak or noisy.
There is multi-path interference. Adjust the FM antenna height or orientation, or place it in a different location.
Your area is too far from the FM station transmitter.
Press MODE to select “Mono” (monaural reception) (p.59).
Use an outdoor FM antenna commercially available. We recommend using a
sensitive multi-element antenna.
AM radio reception is weak or noisy.
The noises may be caused by fluorescent lamps, motors,
thermostats, or other electrical equipment.
It is difficult to completely eliminate noise. It may be reduced by using an outdoor
AM antenna commercially available and properly grounding. Connect it to the
ANTENNA (AM/GND) jack together with the supplied AM antenna.
Radio stations cannot be selected
automatically.
Your area is too far from the FM station transmitter.
Select the station manually (p.59).
Use an outdoor antenna commercially available. We recommend using a
sensitive multi-element antenna.
The AM radio signal is weak.
Adjust the AM antenna orientation.
Select the station manually (p.59).
Use an outdoor AM antenna commercially available. Connect it to the ANTENNA
(AM/GND) jack together with the supplied AM antenna.
AM radio stations cannot be registered
as presets.
“Auto Preset” has been used.
“Auto Preset” is for registering FM radio stations and HD Radio stations only.
Register AM radio stations manually (p.59).
This unit does not receive HD Radio
signals.
This unit is in the monaural reception mode. Press MODE to select “Auto” (p.59).
iTunes Tagging data cannot be
transferred to an iPod.
The iPod is connected to this unit via an iPod dock “YDS-10” or an
iPod wireless system.
The iPod dock “YDS-10” and iPod wireless system do not support tag data
transfer. To transfer tag data, use the USB cable supplied with the iPod, or an
iPod dock “YDS-12” or “YDS-11”.
Problem Cause Remedy
This unit does not detect the USB
device.
The USB cable connecting this unit and USB device is not
compliant with USB 2.0.
Use a USB cable compliant with USB 2.0.
Folders and files in the USB device
cannot be viewed.
The folder structure not supported by this unit is applied.
This unit supports folder hierarchies of up to 8 levels and up to 500 items (total of
files and subfolders) per folder. If necessary, modify the folder structure on your
USB device.
The network feature does not function.
The network parameters (IP address) is not obtained properly.
Enable the DHCP server function on your router and set “DHCP” in the “Setup”
menu to “On” on this unit (p.117). If you want to configure the network parameters
manually, make sure using an IP address which is not used by other network
devices in your network (p.117).