Filter
Top Products
En 124
■ Network
Displays the network information on this unit.
■ System
Displays the system information on this unit.
• If this unit detects a newer firmware over the network, “!” (exclamation mark) appears at the upper right of
the “Information” and “System” icons, and the corresponding message will be displayed in this screen. You
can update the firmware of this unit by pressing ENTER in this screen and following the procedure in
“Updating the firmware of this unit” (p.137).
■ Zone
Displays information about Zone2 and Zone3.
You can configure the system settings of this unit using the front display.
1
Set this unit to standby mode.
2
While holding down STRAIGHT on the font panel, press MAIN ZONE .
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE to set this unit to standby mode and turn it on
again.
The new settings become effective.
IP Address IP address
Subnet Mask Subnet mask
Default Gateway The IP address of the default gateway
DNS Server (P) The IP address of the primary DNS server
DNS Server (S) The IP address of the secondary DNS server
MAC Address MAC address
Status Network connection status
Remote ID The remote control ID setting of the main unit (p.125)
TV Format The video signal type setting of this unit (p.126)
Speaker Impedance The speaker impedance setting of this unit (p.125)
System ID System ID number
Firmware Version The version of firmware installed on this unit
Input The input source selected for Zone2 or Zone3
Volume The volume setting for Zone2 or Zone3
Configuring the system settings
(ADVANCED SETUP menu)
MAIN ZONE
PROGRAM
STRAIGHT