Yamaha HTR-5835 Stereo Receiver User Manual


 
IIl=;,e]l]:l|3.v_:[mImJIiI;[,
Tuner
Refer
Problem Cause Remedy to page
FM stereo reception is 19
noisy.
FM
There is distortion, and
clear reception cannot
be obtained even with a
good FM antenna.
The desired station
cannot be tuned in with
the automatic tuning
method.
The characteristics of FM stereo
broadcasts n:ay cause this problem
when the transmitter is too tar away or
the antenna input is poo:.
Check tile antenna connections.
Tly using a high-quality directional FM
antenna.
Use the ma:mal nming method 33
The:e is multipath interfe:ence Adjust the antenna position to eliminate
multipath interference
The signal is too weak. Use a high-quality directional FM antenna 19
Use the manual tuning method 33
Previously preset This unit has been disconnected for a Preset the stations again. 33
stations can no longer long pe:iod
he tuned in.
The signal is weak or the antenna
connectio:ls are loose.
The desired station
cannot be tuned in with
the automatic tuning
method.
Tighten the AM loop antenna connections
and orient it fbr the best reception
Use the ma:mal nming method 33
AM There are continuous Noises result fiom lightning, Use an outdoor antenna and a ground wire.
crackling and hissing fluorescent lamps, n:otors, the:mostats This will help somewhat, but it is difficult to
noises, and other electrical equipment, eliminate all noise.
There are buzzing and A TV set is being used nearby. Move this unit away flora the T\:
whining noises.
Remote control
Referto
Problem Cause Remedy
page
The remote control W:ong distance o: angle The :emote control will function within a maxinmm 7
does not work nor range of 6 m (20 ft) and no more than 30 degrees off-
function properly, axis flora the front panel
Direct sunlight or lighting (f:om an Reposition this :::lit.
inve:ter _,pe of fluorescent lamp, etc) is
striking the remote conhol sensor of this
:::lit.
The batteries are weak. Replace all batteries. 3
The ren:ote conuol code was not conectly 61
set
Even if the remote control code is
correctly set, there are some n:odels that
do not respond to the remote control.
Set the remote conUol code conectly using "LIST OF
REMOTE CONTROL CODES" at the end of this
mantla].
T:y to set another code for the san:e remote conuol
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual
61
70