Filter
Top Products
Recording adjustments and other operations are
perlbrmed from the recording components. Refer to the
operating instructions for those components.
(U.S.A. model)
2
• \_len this unit is set in the standby mode, you calmot record
between other components connected to this unit.
• The setting of TONE CONTROL, VOLUME, "SP LEVEL"
(page 55) and the sound field pro_ams does not affect recorded
material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• Digital signals input to the DIGITAL INPUT jacks are not
output to the analog AUDIO OUT (L/R) jacks lbr recording.
You can only record analog signals.
• A given input source is not output on the same REC OUT
chmmel. (For example the signal input from VCR IN is not
output on VCR OUT.)
• Check the cop?Tight laws in your country to record from
records, CDs. radio, etc. Recording of copyrighted material may
infringe cop?Tight laws.
If you playback a video source that uses scrambled or
encoded signals to prevent it fi'om being dubbed, the
picture itself may be disturbed due to those signals.
1 Turn on the power of this unit and all
connected components.
2 Select the source component you want to
record from.
INPUT
or
• Special considerations when recording
DTS software
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise
being recorded. Therefore, if you want to use this unit to
record sources that have DTS signals recorded on them,
the following considerations and adjustments need to be
made.
For DVDs and CDs encoded with DTS, when your player
is compatible with the DTS format, follow its operating
instructions to make a setting so that the analog signal will
be output from the player.
Front panel Remote control
3 Start playback (or select a broadcast station)
on the source component.
4 Start recording on the recording component.
Y
Do a test recordingbelbre you start anactual recording.
47