Wolf DCX-1000FD Home Theater System User Manual


  Open as PDF
of 152
 
Wolf Cinema Owner's Manual
3-6
Section3►Operation
Channel
Press
Channel
toselectaspecicsourcesetup(channel)denedandstoredinprojectormemory.
Once you enter a two-digit channel number (or, if there is a list displayed, highlight it and press
), the display will automatically change and update according to the numerous setup
parametersdenedforthatchannel.Notethatanewchannelisautomaticallycreatedifyou
adjust an image from a new source.
NOTE: Channel (
Channel
) key behavior during a presentation depends on whether or not the
Display Channel List option is enabled in the Menu Preferences menu. You can choose to
use a scrollable list of channels when you press
Channel
, or you may prefer to enter the desired
channel number “blind”, i.e., without on-screen feedback. See Menu Preferences later in this
section.
Input 1
Press
Input 1
to display from the data or video input source connected to BNCs labeled INPUT
1.
Input 2
Press
Input 2
to display from the DVI source connected to INPUT 2.
Input 3
Press
Input 3
to display from the composite video source connected to INPUT 3.
Input 4
Press
Input 4
to display from the S-Video source connected to INPUT 4.
Input 5
Press
Input 5
to display from the INPUT 5 interface module installed in the Option 1 slot.
NOTE: If you have the optional Dual SD/HD-SDI Module installed and there are two inputs
connected here, the second input (B) is considered INPUT 7. If you are using the built-in keypad
or the remote keypad, press INPUT 5 to access INPUT 7 as follows:
While displaying from • INPUT 5, press
Input 5
again. This switches to INPUT 7.
While displaying from any input other than the Dual SD/HD-SDI Module, press •
Input 5
. This
switches to either INPUT 5 or INPUT 7, depending on which of the Dual SD/HD-SDI Module
inputs (A or B) was last used. Press
Input 5
again to display from the other Dual SD/HD-SDI
Module input.
Input 6
Press
Input 6
to display from the INPUT 6 interface module installed in the Option 2 slot.
NOTE: If you have the optional Dual SD/HD-SDI Module installed and there are two inputs
connected here, the second input (B) is considered INPUT 8. If you are using the built-in keypad
or the remote keypad, press INPUT 6 to access INPUT 8 as follows:
While displaying from • INPUT 6, press
Input 5
again. This switches to INPUT 8.
While displaying from any input other than the Dual SD/HD-SDI Module, press •
Input 5
, which
switches to either INPUT 5 or INPUT 8, depending on which of the Dual SD/HD-SDI Module
inputs (A or B) was last used. Press
Input 5
again to display from the other Dual SD/HD-SDI
Module input.
Channel
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
 previous next