Wolf DCX-1000FD Home Theater System User Manual


  Open as PDF
of 152
 
Wolf Cinema Owner's Manual
D-1
APPENDIX D
SYSTEM INTEGRATION
The GPIO (General Purpose Input Output) connector located on the input panel provides a
exiblemethodofinterfacingawiderangeofexternalI/Odevicestotheprojector.Thereare
sevenGIOpinsavailableonthenine-pinD-SubGPIOconnector,whicharecongurablevia
RS232 commands. The other two pins are reserved for ground and power – see table below for
pinidentication.
GPIO Pins GPIO
Pin # Signal
1 + 12V (1200mA)
2 GPIO 1
3 GPIO 2
4 GPIO 3
5 Ground
6 GPIO 4
7 GPIO 5
8 GPIO 6
9 GPIO 7
Conguring the GPIO
TheGPIOconnectorcanbeconguredtoautomateanynumberofeventsusingtheserial
commandcode GIO.Eachpin isdened aseither aninputoroutputdepending onthe
desired outcome. Ingeneral, congure thepin as aninput if youwant the projectorto
respond to something the external device does and as an output if you want the external
devicetorespondtoanactiontakenbytheprojector.Forexample,congurethepinasan
output if you want the lighting in a room to automatically dim when the projector is turned
on.
By using the GIO command, you can also set the state of each pin as high or low. By default,
the state of each pin is high. The voltage applied to pins in the high state is + 3.3V.
Example 1. Turn room lighting on when the projector is turned off. (Assumes a control/
automation unit is congured to turn the lights on when pin 2 of its input goes high.)
(GIO C2 O) Set pin #2 conguration to output
(GIO 2 H) Set pin #2 to high (state)
Query Command
(GIO?) Request the state and conguration of all pins
(GIO! “HHLLHLH” “OOIOOOI”) Reply of pin state and conguration
(GIO? C2) Request conguration for pin #2
(GIO! C2 O) Reply with pin #2 conguration as output
(GIO? 2) Request the state of pin #2
(GIO! H) Reply with pin #2 state as high
The serial cable required for connecting
the external device to the projector’s GPIO
connector, whether it’s a standard serial cable
or a custom one, must be compatible with the
external device.
 previous next