Wolf DCX-1000FD Home Theater System User Manual


  Open as PDF
of 152
 
Wolf Cinema Owner's Manual
B-28
3.72 ITG
Test Pattern Grey
ITG Test Pattern Grey
UseITG tosetthe greylevel fortheat eldinternaltestpattern.The rangeofadjustment
depends on the bit depth available in your projector model.
UseITPtodisplayaninternaltestpattern,ortondoutwhattestpatterniscurrentlydisplayed.
The basic test pattern collection is shown listed below - your projector may vary slightly.
Pattern # Description
0 User image - no test pattern displayed.
1 Grid + grey scale + color bars + circle + convergence marks
2 Gray Scale 16
3 White
4 Grey - slide bar selects value 0-1023
5 Black
6 Checker
7 13 point
8 Color Bars
9 RGBW Grey Scale
10 Multi Color
11 Edge Blend
12 Aspect Ratio
13 Red & Blue ramp
KEN Keypad Enable
Use KEN to set the keypad input protocols, Wired, IR Front and IR Rear, to respond to the
protocol of the desired keypad. The following table outlines how to use the command parameters
to set the desired protocols. Note: the built-in keypad cannot be disabled.
NOTE: Protocols B – G are used with the ‘Brick’ style rental staging keypad.
Parameter Value
P1 0 = Wired
1 = IR Front
2 = IR Rear
P2 0 = Off
1 = Responds to any protocol
10 = Protocol A
11 = Protocol B
12 = Protocol C
13 = Protocol D
14 = Protocol E
15 = Protocol F
16 = Protocol G
Example:
(KEN I2 12): Sets IR Rear to Protocol C
(KEN? I1) returns (ken! I001 001): the current protocol for IR-front
3.73 ITP
Internal Test Pattern
3.74 KEN
Keypad Enable
AppendixB►SerialCommunications
 previous next