Filter
Top Products
31
8.10. Compressor Settings (only when the compressor mode is selected in Section 8.9.)
Note
No following displays appear when the auto-leveler mode is selected.
ON
When any of the following screens is displayed, the compression function for the displayed channel
can be enabled or disabled with the function ON/OFF key. When enabled (ON), the function
ON/OFF Indicator lights.
RatioThreshold level Attack time Release time Makeup gain
Compressor/auto-leveler mode selection (previous section)
Level sense settings (p. 34)
[ IN 1 ] COMP
T HR ES H + 0 d
B
[IN 1] COMP
RATIO 1:1
[IN 1] COMP
ATTACK
1
0.0
m
s
[IN 1] COMP
R E L EA S E 5 0 0
m
s
[IN 1] COMP
GA IN +0
d
B
8.10.1. Threshold level settings
[IN 1] COMP
THRESH +0d
B
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the threshold level.
Parameter setting range: –20 to +20 dB in 1 dB steps
• Pressing an Input channel selector key permits the compression
threshold level to be set for that channel. The [IN 1] indication
changes to the selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
[Screen display operations]
8.9. Compressor/Auto-Leveler Mode Selection
Select which function to use, compressor (next section) or auto-leveler (p. 33).
[ I N 1 ] COMPMODE
C
O
M P
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to select compressor mode (COMP) or
auto-leveler mode (LEVELER). Selecting the mode enables its
corresponding function.
Refer to the next section for the compressor settings, and p. 33
for the auto-leveler settings.
• Changing the mode cancels the parameters for the newly
selected mode even they have been preset, returning them to the
default settings.
• Pressing an Input channel selector key permits the compressor
mode or the auto-leveler mode to be set for that channel.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
Equalizer Settings
(previous page)
Compressor settings
(next section) or
auto-leveler settings (p. 33)