Filter
Top Products
19
9.2. Zone Paging
This section describes the method of initiating zone paging from a PABX (extension telephone) using the ZP-
001T Zone Paging Module. Note that the operation method differs depending on the ZP-001T's operation
mode setting: paging trunk mode or ring signal mode.
9.2.1. Paging trunk mode
Step 1. Activate the paging trunk from the extension telephone.
Since this method differs depending on the type of exchange, please read the instruction manual for
the extension telephone.
When the paging trunk is activated and the control input terminal is closed, the ZP-001T module
connects the line.
Step 2. Select the output channel.
Press [0] first, followed by the output channel number ([1] – [8] or [9] when selecting all numbers
simultaneously). Pressing the [#] key completes the output channel selection.
Example: To select Outputs 2 and 3, press [0] [2] [3] [#].
To make an all-zone call, press [0] [9] [#].
Step 3. Begin paging when a pre-paging tone is heard from the handset.
The pre-paging tone can be set to be transmitted to all the selected output channels as well.
(The pre-paging tone ON or OFF cannot be individually set for the selected output channels.)
Step 4. Deactivate the paging trunk to terminate paging.
Since this method differs depending on the type of exchange, please read the instruction manual for
the extension telephone.
9.2.2. Ring signal mode
Step 1. Make a call from the extension telephone to the ZP-001T module.
After all call tone sounds twice, the ZP-001T receives the call and a callback tone is heard from the
handset.
Step 2. Select the output channel.
Press [0] first, followed by the output channel number ([1] – [8] or [9] when selecting all numbers
simultaneously). Pressing the [#] key completes the output channel selection.
Example: To select Outputs 2 and 3, press [0] [2] [3] [#].
To make an all-zone call, press [0] [9] [#].
Step 3. Begin paging when a pre-paging tone is heard from the handset.
The pre-paging tone can be set to be transmitted to all the selected output channels as well.
(The pre-paging tone ON or OFF cannot be individually set for the selected output channels.)
Step 4. To terminate paging, press [0] [0] [#] or replace the handset.
If dialing [0] [0] [#]: Pressing a first [0] terminates paging (a DTMF tone for the first [0] is output),
and the ZP-001T disconnects the line after the [#] has been pressed.
If replacing the handset: After a signal tone is transmitted 3 times, the paging is terminated and the
line disconnected.