Filter
Top Products
Installation
1-16
CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
5. In the BIOS Setup Utility, use the right-arrow key on the keyboard to
highlight the Advanced menu at the top of the screen.
6. Use the arrow down key to highlight PCI Configuration (Peripheral
Configuration on some instruments) in the Advanced screen, and then press
Enter.
7. Use the arrow down key to highlight Embedded Ethernet Controller (LAN
Device on some instruments) in the Peripheral Configuration screen, and
then press Enter.
8. Use the arrow up or down key to highlight Enabled, and then press Enter.
9. Press the F10 key to save and exit. Confirm the Save of Configuration
changes when you are prompted on screen.
10. Use the Windows network setup utility to define the instrument as a network
client and configure it for your network. You can find the network setup
utility in the Windows Start menu if you select Settings > Control Panel
and then double click Network. You should consult your network adminis-
trator for specific instructions to make these settings.
NOTE. If you want to disable network access for the instrument, perform the
above procedure except substitute Disabled for the command listed in step 8. The
instrument will boot faster with network access disabled.