Filter
Top Products
Data Input/Output
3- 248
CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
If Count reaches 999, it is suggested that you change the base file name to
Basefilename1 (for example, Risetime1) on the next save. Your next file will
then be saved as Risetime1000.ext.
Use the procedure that follows to save a setup to one of ten internal locations, the
instrument hard disk, a floppy disk, or third-party storage device.
Overview To save your setup Control elements and resources
Prerequisites 1. The instrument must be powered up.
2. Setup the instrument controls as you want them saved
as part of a recallable setup.
For help in making your setup, check the references at
right and other sections in this chapter speci fic to the
setup you wish to make.
H See Powering On the Instrument on page 1--9.
H See page 3--34 for acquisition setup.
H See page 3--71 for trigger setup.
Display the
setups control
window
3. From the toolbar, touch Setups and select the Save
Setups tab of the Setups control window.
Save the setup 4. Touch the number of the setup in which you want to
save your setup. Data in the existing setup wil l be
overwritten.
To Save Your Setup