Filter
Top Products
Appendix A. Specifications
77
220-Volt AC Power Cord for Use in North America
The criteria for a U.S. and Canadian 220-volt AC power cord for the library are as
follows:
• Power cord must have a molded NEMA 6-15P attachment plug on one end.
• Power cord must have a molded IEC type CEE-22 female connector to connect to
the library.
• Cordage must be SJT type, three-conductor, 18 AWG minimum.
• Power cord must comply with local electrical code.
220-Volt AC Power Cord for International Use
The criteria for an international 220-volt AC power cord are as follows:
• Power cord must have an attachment plug of the proper type, rating, and safety
approval for the intended country.
• Power cord must have an IEC type CEE-22 female connector on one end to connect
the library.
• Cord must be a flexible, HAR (harmonized) type H05VV-F, three-conductor, cord
with minimum conductor size of 0.03 square inches (1.0 square millimeters).
Library Operating Environment Limits
Place the library and media in a reasonably controlled environment that does not
exceed the environment limits listed in the table below:
Condition Minimum Maximum
Operating Temperature (Ambient Outside Library) 2° C
35.6° F
30° C
86° F
Storage Temperature -40° C
-°104 F
65° C
149° F
Relative Humidity (non-condensing) 20% 80%
Maximum Wet Bulb Temperature N/A 26° C
Altitude 0 m
Sea level
3,000 m
9,842 ft