Filter
Top Products
Appendix A. Specifications
76
Library Power Requirements
Power requirements for the library are summarized in the table below:
Fuses
The library includes two 1/4-inch x 1-1/4-inch or 5 mm x 20 mm (3AG), 250-volt AC,
2A slow fuses. For complete instructions on replacing fuses, see Replacing the Fuses on
page 59.
Caution: For continued fire protection, replace fuses only with the
specified type and rated fuses.
Power Cable
The power cable included with the library is a standard, three-conductor, 18 AWG
power cord, safe for 120-volt use in the United States and Canada. The cable has a
molded NEMA 5-15P male connector to plug in the wall and a molded IEC type CEE-22
female connector to plug into the library.
Note: To use the library outside of the United States or Canada, the power
cord must meet the specifications for that country.
Source Requirements
Input Voltage 100-240 volts-AC; 2 A maximum
Input Power 90 Watts minimum, 120 Watts maximum
Input Frequency 50/60 Hz