Filter
Top Products
78
US
The aspect ratio of the TV screen cannot be
changed even though you can set “TV TYPE”
under “SCREEN SETUP” in the Setup Menu
when you play back a wide picture.
• The aspect ratio is fixed on your DVD VIDEO.
• If you connect the unit with the S Video cord,
connect directly to the TV. Otherwise, you may
not change the aspect ratio.
• Depending on the TV, you may not change the
aspect ratio.
Messages do not appear on the TV screen in
the language you want.
• Select the language you want for the on-screen
display in “OSD” under “LANGUAGE SETUP”
in the Setup Menu (page 41).
The language for the sound track cannot be
changed.
• Multilingual tracks are not recorded on the DVD
VIDEO being played back.
• The DVD VIDEO prohibits changing the
language for the sound track.
The subtitles language cannot be changed.
• Multilingual subtitles are not recorded on the
DVD VIDEO being played back.
• The DVD VIDEO prohibits changing the
subtitles.
The subtitles cannot be turned off.
• The DVD VIDEO prohibits turning off subtitles.
The angles cannot be changed.
• Multi-angles are not recorded on the DVD
VIDEO being played back.
• The DVD VIDEO prohibits changing the angles.
Tuner
There is severe hum or noise. (“TUNED” or
“STEREO” flashes in the display)
• Set the proper band and frequency (page 47).
• Connect the antenna properly (page 10).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend that
you connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Try turning off the surrounding electrical
equipment.
A stereo FM program cannot be received in
stereo.
• Press FM MODE repeatedly until “MONO”
disappears from the display.
Tape deck
The tape does not record or playback, or there
is a decrease in sound level.
• The tape heads are dirty (see “Cleaning the tape
heads” on page 82).
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 82).
The tape does not erase completely.
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 82).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty (see
“Cleaning the tape heads” on page 82).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 82).
The tape does not record.
• No tape is loaded. Load a tape.
• The tab has been removed from the tape. Cover
the broken tab with adhesive tape (page 82).
• The tape has reeled to the end.
When you press . or >, “Not in Use”
flashes in the display.
• The system does not have AMS (Automatic
Music Sensor) function. This is not a malfunction.
The recorded sound has echo effect.
• Before you start recording, press FLANGER and
DELAY repeatedly until the FLANGER and
DELAY indicators light off.
• (FST-ZX100D/LBT-ZX100D/FST-ZX80D/
LBT-ZX80D only)
Before you start recording, press CHORUS
repeatedly until the CHORUS indicator lights off.