Sony TA-VA777ES Stereo Amplifier User Manual


 
11
GB
Hooking Up the Components
CONTROL A1 hookup
If you have a CONTROL A1 compatible Sony
CD player, tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
CONTROL A1
jack on the CD player, tape deck, or
MD deck to the CONTROL A1
jack on the amplifier.
Refer to “CONTROL A1
Control System” on page 49
and the operating instructions supplied with your CD
player, tape deck, or MD deck for details.
Note
If you make CONTROL A1 connections from the amplifier to
an MD deck that is also connected to a computer, do not
operate the amplifier while using the “Sony MD Editor”
software. This may cause a malfunction.
If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer’s COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to “CD 1” and connect the changer to
the CD jacks on the amplifier.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to “CD 2” and
connect the changer to the VIDEO 2 jacks on the
amplifier.
Connecting the AC power cord
Before connecting the AC power cord of this amplifier to a
wall outlet:
Connect the speaker system to the amplifier (see page
13).
Turn the MASTER VOLUME control to the leftmost
position (0).
Connect the AC power cord(s) of your audio/video
components to a wall outlet.
If you connect other audio/video components to the AC
OUTLET(s) on the amplifier, the amplifier will supply
power to the connected component(s), allowing you to
turn the whole system on or off when you turn the
amplifier on/off.
Caution
Make sure that the total power consumption of the component(s)
connected to the amplifier’s AC OUTLET(s) does not exceed the
wattage stated on the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons, fans, or TVs to
this outlet.
Note
If the AC power cord is disconnected for about two weeks, the
amplifier’s entire memory will be cleaned and the demonstration
will start.